Please Note: As this is a high-end billiard table, QBilliards recommends that you use a
professional installer, however if you feel that you can do the installation on your own
QBilliards has compiled a set of installation guidelines for your convenience.

Hardware Code	B1	B2	B3	S1	W1	W2	W3
Quantity	22	8	12	16	22	8	12
Usage	Rail & Leg	Leg	Pocket	Slate	Rail & Leg	Leg	Pocket

Step 1
	Mount both pockets onto the end rail with (B3) & (W3)

Step 2
	Mount the side rails onto the pockets using (B3) & (W3) that were mounted in Step 1.

Step 3
	You should now have 3 rails connected by 2 pockets. Now mount the next 2 middle pockets.

Step 4
	Very carefully and with a helper turn the 3 rails and 4 pockets over and bolt the rails to the slate with (B1) and (W1), at this stage it is only necessary to tighten the bolts finger tight. Repeat Step 1, Step 2 and Step 4 and use (B3) & (W3) to secure the pockets to the rail assembly.

Square up all the rails and looking down the length of the table, straighten the side rails and tighten the bolts.