 |
 |
 |
 |
 |
|
 |
 |
 |
 |
 |
 |
 |
 |
|
|
|
|
|
|
 |
Your billiard table light is made up of 5 parts, each part is solid wood. |
 |
 |
With the locating dowels join an end to a side. |
 |
Pre-drill 5/64" (2mm) holes for all the screws.
CAUTION: Make sure that the holes are drilled through the middle of the wood, a misaligned drill could exit the wood. |
 |
Insert the 3 screws into the pre-drilled holes and tighten. |
 |
Attach the second end piece in the same way as step one and step two. |
 |
Attach the last side piece in the same way as step one and step two. |
 |
Align the top so that it is centered on all four sides. |
 |
Pre-drill a very small hole (we will drill the full length in the next step) |
 |
Make sure that the mark that you made in step six is in the middle of the side piece, then drill the full length hole making sure that the hole runs through the middle of the wood. Screw in the first screw and realign the top, now do the same for the opposing corner. Once you have two screws inserted you can pre-drill the remaining 6 holes, taking care to keep all the holes in the center of the wood. |
 |
You are now ready to install the light fittings and chain of your choice. The light is designed to accept a 4 foot flourescent fitting, however, other lighting (spots, floods ect) options are simple to install. |
........................................................................................................................................ |
If you have any questions regarding any of our products please feel free to email us at
or
Toll Free 1 866 816 1128 Fax 1 250 479 6735
|